WhatsApp)
Apr 11, 2017#0183;#32;The grinding balls unload from the mill into a special pit (needs to open hatches and pour the grinding balls from the drum during mill scroll). Then, need to definition maximum and minimum grinding balls diameter located in the mill.
b max is the maximum ball diameter in a charge, d is the characteristic top limit of the material size which is being ground (d 95 or d 80 in the formulae is recommended for industrial mills); K and n are parameters, for which all authors say to be dependent on the mill characteristics, grinding conditions and characteristics of the material
In Grinding, selecting (calculate) the correct or optimum ball size that allows for the best and optimum/ideal or target grind size to be achieved by your ball mill is an important thing for a Mineral Processing Engineer AKA Metallurgist to do. Often, the ball used in ball mills is oversize just in case. Well, this safety factor can cost you much in recovery and/or mill liner wear and
Selection of Volume of Ball Loads in Continuous Dry Open Circuit Grinding: The tests reported in tables 19 and 20 were made in cooperation with a large cementmanufacturing company that wished to obtain more grinding for the power expended. The ball load in its clinker grinding mills was 18 percent of the mill volume and the company did not deem it consistent to increase the ball load because
Add to this another 45% to 50% above the ball charge for total of 58% to 63% product loading. This level of liquid loading should leave some air space above the liquid to allow for expansion of the liquid as it heats up during the milling process. So as a rule of thumb we use a maximum of 60% liquid loading.
Sep 01, 2013#0183;#32;A grinding circuit simulation combined with ball weal law was used to determine the optimum composition of the makeup ball sizes in tumbling ball mills. It was found that the optimum composition depends on various factors, including the feed size, the product size, the mill diameter and the breakage parameters.
WhatsApp)